manual RESET button new part: 260 g force, shorter actuator One of the main envisioned use cases for FC Venus is field demonstration: the board will be carried around, mounted on a sheet of acrylic or somesuch, it will have a battery and an antenna connected, there will be a test SIM with active service inserted, and the setup will be ready to demonstrate as a working phone at a moment's notice. But when a demo is not actively in progress, the fully assembled setup will be transported around in a big and loose ESD bag, and it will need to be equivalent to a traditional phone in its switched-off state: battery present, RTC keeping time, but not switched on all the time. Having a RESET button of the same keyswitch type as used for the regular keypad and PWON would cause a problem for such field transport scenarios: any spurious press of this button would cause a "misc boot" switch-on. Short spurious presses of PWON are filtered out by the firmware (automatic power-off if the button isn't held down long enough), but the same cannot be done for super-low-level nTESTRESET. However, a button with significantly greater operating force and a shorter actuator (not sticking out to the same height as the regular keypad buttons) should be much safer.

module regulator_ic (IN, OUT, GND, EN);

input IN, GND, EN;
output OUT;

pkg_IC_5pin pkg (.pin_1(IN),
		 .pin_2(GND),
		 .pin_3(EN),
		 .pin_4(),	/* no connect */
		 .pin_5(OUT)
	);

endmodule