--- a/doc/Freerunner-Howto	Sat Apr 23 05:03:38 2016 +0000
+++ b/doc/Freerunner-Howto	Sat Apr 23 05:17:15 2016 +0000
@@ -46,8 +46,9 @@
 
 2. You should get a flashImage.bin image built; now you need to flash it into
    your FR's modem.  The serial cable method is highly recommended: the only
-   thing you'll be able to do with our current non-working firmware is help us
-   debug it, and the serial cable will be needed for the latter part anyway.
+   thing you'll be able to do with our current not-fully-functional firmware is
+   play with it and observe the debug output, and the serial cable will be
+   needed for the latter part anyway.
 
 3. Run fc-loadtool the same way you would if you were flashing leo2moko;
 
@@ -96,15 +97,6 @@
 AT+CFUN=1	-- enable radio and SIM interfaces
 AT+COPS=0	-- register to the default GSM network
 
-Our fw is currently able to exercise all SIM interface functions (at least the
-obvious ones which I've tested), register with a live commercial GSM network
-using a legitimate SIM, and send and receive SMS using standard GSM 07.05 AT
-commands.  Voice calls don't work yet: you can dial a MO call with the ATD
-command and you can place a MT call to the device under test from the network
-side and then answer it with ATA, these calls connect successfully, but the
-voice audio fails to pass through: nothing but noise is heard in the earpiece
-speaker.  See the Firmware_Status write-up for more information.
-
 To reflash your modem back to stable and working leo2moko aka moko12, execute
 the following fc-loadtool commands: