+
−# If one is running fc-loadtool from inside the GTA02 (i.e., from the AP,
+
−# as opposed to an external host connected via the headset jack), the
+
−# following setting will cause the fc-loadtool utility to power the modem off
+
−# fully upon exit.
+
−
+
−exit-mode gta02-cutpwr
+
−
+
−# The following parameters go into the <p command sent to the boot ROM
+
−# same values as in pirelli.config, apparently correct for this modem too
+
−
+
−pll-config 4/1		# 26 MHz in, PLL&DSP @ 104 MHz, ARM @ 52 MHz
+
−rhea-cntl 0x00		# fastest setting, used by OsmocomBB, presumably correct
+
−
+
−# Configure memory timings with loadagent commands
+
−init-script k5a3281.init
+
−
+
−# Flash type and chip select base address (full access mapping)
+
−flash k5a32xx_t 0x03000000