FreeCalypso > hg > freecalypso-sw
view target-utils/README @ 884:353daaa6014d
gsm-fw/gpf/conf/gsmcomp.c: increased max partition in the voice-only config
The code we got from TCS211 had the maximum prim pool partition size set to
900 bytes in the voice-only config (no FAX_AND_DATA, no GPRS) and to 1600 bytes
in every other config. As it turns out, this "minimized" config breaks when
the AT command interface is used with %CPI enabled, as the responsible code in
ATI does an ACI_MALLOC of 1012 bytes. TI may have considered this case to be
unsupported usage (perhaps they didn't care about the combination of a
voice-only PS with AT command control), but we do want this use case to work
without crashing. Solution: I made the largest prim pool the same as it is
with FAX_AND_DATA: 3 partitions of 1600 bytes.
| author | Space Falcon <falcon@ivan.Harhan.ORG> |
|---|---|
| date | Sat, 27 Jun 2015 07:31:30 +0000 |
| parents | 4391890bacd9 |
| children |
line wrap: on
line source
The following target utilities or code components are currently buildable in this target-utils tree: compalstage For Compal phones only: a little piece of code that is fed to the original fw's bootloader via the serial download protocol provided by the latter; it re-enables the Calypso chip boot ROM and jumps to it, allowing our loadagent to be loaded in the same way as on freedom-enabled devices. helloapp Template/skeleton for building programs like loadagent and pirexplore. loadagent Loadagent is built to be loaded and run out of the Calypso internal (on-chip) RAM, and does not depend on any hardware outside of the Calypso chip itself - thus it should run unchanged on all Calypso targets. It expects to be loaded by the Calypso ROM bootloader in the UART download mode, and it reads a RAM variable left behind by the ROM code that indicates which UART has been used to perform that download - it then uses that same UART to communicate with the host, presenting an interactive command prompt. You can run loadagent "raw" by loading loadagent.srec with fc-iram, but normally it is used "behind the scenes" by fc-loadtool and fc-xram. pirexplore For Pirelli DP-L10 target only: this program is built in the same manner as loadagent (also runs out of IRAM, expects to be loaded with fc-iram, and presents an interactive command prompt on the autodetected UART), but it automatically performs some hardware (board level) initialization specific to the Pirelli, and offers additional commands for exploring the hardware features of this device. tf-breakin Here we build the payload for the tfc139 hack-utility; see ../rvinterf/lowlevel/tfc139.c for the ugly details.