view loadtools/scripts/compal.init @ 983:7166c8311b0d

tfc139 reworked to support both ARM and Thumb entry
author Mychaela Falconia <falcon@ivan.Harhan.ORG>
date Thu, 10 Dec 2015 08:07:47 +0000
parents 326363ba5bf4
children
line wrap: on
line source

# Set WS=3 for both nCS0 and nCS1.  This configuration is used by OsmocomBB
# for all 3 Compal models (E86/88/99), and is also seen in the IDA disassembly
# listing of c115-1.0.46.E firmware contributed by Christophe Devine.

w16 fffffb00 00A3
w16 fffffb02 00A3

# We need to set the FFFF:FB10 register to map the flash (not the boot ROM)
# to address 0.  We need this mapping in order to be able to dump and program
# the entire flash, as for some reason the alternate nCS0 mapping at 0x03000000
# does not work on Compal phones.  (That alternate mapping works fine on
# Openmoko and Pirelli phones, though.  Perhaps the different Calypso chip
# version is the culprit, or perhaps this alternate mapping works only if the
# physical nIBOOT pin is low.)

w16 fffffb10 0300