# If one is running fc-loadtool from inside the GTA02 (i.e., from the AP,
# as opposed to an external host connected via the headset jack), the
# following setting will cause the fc-loadtool utility to power the modem off
# fully upon exit.

exit-mode gta02-cutpwr

# The following parameters go into the <p command sent to the boot ROM
# same values as in pirelli.config, apparently correct for this modem too

pll-config 4/1		# 26 MHz in, PLL&DSP @ 104 MHz, ARM @ 52 MHz
rhea-cntl 0x00		# fastest setting, used by OsmocomBB, presumably correct

# Configure memory timings with loadagent commands
init-script k5a3281.init