comparison loadtools/scripts/compal.init @ 0:e7502631a0f9

initial import from freecalypso-sw rev 1033:5ab737ac3ad7
author Mychaela Falconia <falcon@freecalypso.org>
date Sat, 11 Jun 2016 00:13:35 +0000
parents
children ac48ed111d6a
comparison
equal deleted inserted replaced
-1:000000000000 0:e7502631a0f9
1 # Set WS=3 for both nCS0 and nCS1. This configuration is used by OsmocomBB
2 # for all 3 Compal models (E86/88/99), and is also seen in the IDA disassembly
3 # listing of c115-1.0.46.E firmware contributed by Christophe Devine.
4
5 w16 fffffb00 00A3
6 w16 fffffb02 00A3
7
8 # We need to set the FFFF:FB10 register to map the flash (not the boot ROM)
9 # to address 0. We need this mapping in order to be able to dump and program
10 # the entire flash, as for some reason the alternate nCS0 mapping at 0x03000000
11 # does not work on Compal phones. (That alternate mapping works fine on
12 # Openmoko and Pirelli phones, though. Perhaps the different Calypso chip
13 # version is the culprit, or perhaps this alternate mapping works only if the
14 # physical nIBOOT pin is low.)
15
16 w16 fffffb10 0300