FreeCalypso > hg > freecalypso-tools
view loadtools/scripts/gta02.config @ 561:392525355ee7
loadtools/scripts: gtm900.config renamed to gen4.config
It turns out that a GTM900 variant exists with 8 MiB flash, thus -h gen8
needs to be used for GTM900 modules as the general case, and the old
-h gtm900 config is best renamed to -h gen4, although not currently official
for any actual target.
| author | Mychaela Falconia <falcon@freecalypso.org> |
|---|---|
| date | Thu, 30 Jan 2020 07:10:20 +0000 |
| parents | 49ee210fc4fb |
| children | 4a199ff4b23f |
line wrap: on
line source
# If one is running fc-loadtool from inside the GTA02 (i.e., from the AP, # as opposed to an external host connected via the headset jack), the # following setting will cause the fc-loadtool utility to power the modem off # fully upon exit. exit-mode gta02-cutpwr # The following parameters go into the <p command sent to the boot ROM # same values as in pirelli.config, apparently correct for this modem too pll-config 4/1 # 26 MHz in, PLL&DSP @ 104 MHz, ARM @ 52 MHz rhea-cntl 0x00 # fastest setting, used by OsmocomBB, presumably correct # Configure memory timings with loadagent commands init-script k5a3281.init # Flash access mapping flash single-4M 0x03000000