FreeCalypso > hg > freecalypso-tools
view loadtools/scripts/fcfam.config @ 505:7bf0d909c87e
fc-loadtool flash ID check: change of reset after the check logic
This change only affects those flash configurations that have ID checks
enabled. The logic for resetting the flash after the ID check has been
changed as follows:
1) If the check fails, we return without attempting to reset the flash.
2) If the check is successful, we reset the flash using the configured
method (could be AMD or Intel or Intel W30) instead of always doing an
AMD flash reset as the original code did.
author | Mychaela Falconia <falcon@freecalypso.org> |
---|---|
date | Mon, 27 May 2019 19:58:01 +0000 |
parents | e7502631a0f9 |
children | 49ee210fc4fb |
line wrap: on
line source
# This loadtool target configuration is intended to be applicable to all # original hardware designs created within the FreeCalypso project, # starting with FCDEV3B. Specifically, it should fit all targets that # satisfy the following criteria: # # The DBB chip is Calypso C035 # The RF block is Rita (26 MHz VCXO) # Spansion S71PL129NC0 used for flash and XRAM, copied from Pirelli DP-L10 # The 2nd flash chip select is wired to nCS2 # The following parameters go into the <p command sent to the boot ROM pll-config 4/1 # 26 MHz in, PLL&DSP @ 104 MHz, ARM @ 52 MHz rhea-cntl 0x00 # good for all Calypso platforms # The remaining settings are carried out via loadagent commands init-script cs2-4ws-8mb.init # Flash type and chip select base addresses flash pl129n 0x03000000 0x01800000 # Perform a Iota poweroff when we are done exit-mode iota-off