ringtools/imy: fix duplicate definition of tdma_durations[] The bug was reported by Vadim Yanitskiy <fixeria@osmocom.org>, although the present fix is slightly different from the contributed patch: because main.c doesn't need this tdma_durations[] array at all, let's simply remove the reference to this array from main.c rather than turn it into an extern. I no longer remember my original thought flow that resulted (by mistake) in tdma_durations[] being multiply defined in main.c and durations.c. My intent might have been to define all globals in main.c and have the reference in durations.c be an extern - and I missed that extern - but without clear memory, I have no certainty. In any case, having this data array defined in the same module that fills it (durations.c) is sensible, so let's make it the new way.

# This config is meant to be applicable to most "generic" or "vanilla"
# Calypso devices with just the following properties expected:
#
# * Calypso chip is C035, meaning it's ok to run the PLL at 104 MHz
#   and give 52 MHz to the ARM7;
# * There is one flash bank on nCS0 and one XRAM bank on nCS1;
# * No more than 4 MiB flash, thus no ADD22.

# The following parameters go into the <p command sent to the boot ROM
pll-config 4/1		# 26 MHz in, PLL&DSP @ 104 MHz, ARM @ 52 MHz
rhea-cntl 0x00		# good for all Calypso platforms

# The remaining settings are carried out via loadagent commands
init-script basic-4ws-4mb.init

# Flash configuration
flash single-4M 0x03000000

# Perform a Iota poweroff when we are done
exit-mode iota-off