FreeCalypso > hg > freecalypso-tools
view loadtools/scripts/fcfam.config @ 924:d452188587b4
rvinterf: begin change to backslash escape output format
Right now throughout the rvinterf suite, any time we emit output that
is expected to be ASCII, but may contain non-printable garbage, we use
'cat -v' form of garbage character representation. Unfortunately, this
transformation is lossy (can't be reversed 100% reliably in the user's
wetware), hence we would like to migrate to C-style backslash escapes,
including doubling of any already-present backslashes - this escape
mechanism is lossless. Begin this change by converting the output
of RV and L1 traces in rvinterf and rvtdump.
author | Mychaela Falconia <falcon@freecalypso.org> |
---|---|
date | Tue, 23 May 2023 03:10:50 +0000 |
parents | 49ee210fc4fb |
children |
line wrap: on
line source
# This loadtool target configuration is intended to be applicable to all # original hardware designs created within the FreeCalypso project, # starting with FCDEV3B. Specifically, it should fit all targets that # satisfy the following criteria: # # The DBB chip is Calypso C035 # The RF block is Rita (26 MHz VCXO) # Spansion S71PL129NC0 used for flash and XRAM, copied from Pirelli DP-L10 # The 2nd flash chip select is wired to nCS2 # The following parameters go into the <p command sent to the boot ROM pll-config 4/1 # 26 MHz in, PLL&DSP @ 104 MHz, ARM @ 52 MHz rhea-cntl 0x00 # good for all Calypso platforms # The remaining settings are carried out via loadagent commands init-script cs2-4ws-8mb.init # Flash global config and chip select base addresses flash dual-8M 0x03000000 0x01800000 # Perform a Iota poweroff when we are done exit-mode iota-off