FreeCalypso > hg > freecalypso-tools
view loadtools/scripts/gen8.config @ 924:d452188587b4
rvinterf: begin change to backslash escape output format
Right now throughout the rvinterf suite, any time we emit output that
is expected to be ASCII, but may contain non-printable garbage, we use
'cat -v' form of garbage character representation. Unfortunately, this
transformation is lossy (can't be reversed 100% reliably in the user's
wetware), hence we would like to migrate to C-style backslash escapes,
including doubling of any already-present backslashes - this escape
mechanism is lossless. Begin this change by converting the output
of RV and L1 traces in rvinterf and rvtdump.
author | Mychaela Falconia <falcon@freecalypso.org> |
---|---|
date | Tue, 23 May 2023 03:10:50 +0000 |
parents | 641d816b1e91 |
children |
line wrap: on
line source
# This config is meant to be applicable to most "generic" or "vanilla" # Calypso devices with just the following properties expected: # # * Calypso chip is C035, meaning it's ok to run the PLL at 104 MHz # and give 52 MHz to the ARM7; # * There is one flash bank on nCS0 and one XRAM bank on nCS1; # * 8 MiB flash chip may be present, thus ADD22 needs to be enabled. # The following parameters go into the <p command sent to the boot ROM pll-config 4/1 # 26 MHz in, PLL&DSP @ 104 MHz, ARM @ 52 MHz rhea-cntl 0x00 # good for all Calypso platforms # The remaining settings are carried out via loadagent commands init-script basic-4ws-8mb.init # Flash configuration flash single-8M 0x03000000 # Perform a Iota poweroff when we are done exit-mode iota-off