rvinterf: begin change to backslash escape output format Right now throughout the rvinterf suite, any time we emit output that is expected to be ASCII, but may contain non-printable garbage, we use 'cat -v' form of garbage character representation. Unfortunately, this transformation is lossy (can't be reversed 100% reliably in the user's wetware), hence we would like to migrate to C-style backslash escapes, including doubling of any already-present backslashes - this escape mechanism is lossless. Begin this change by converting the output of RV and L1 traces in rvinterf and rvtdump.

# The following parameters go into the <p command sent to the boot ROM

pll-config 4/1		# 26 MHz in, PLL&DSP @ 104 MHz, ARM @ 52 MHz
rhea-cntl 0x00		# fastest setting, used by OsmocomBB, presumably correct

# The remaining settings are carried out via loadagent commands
init-script pirelli.init

# Flash global config and chip select base addresses
flash dual-8M 0x03000000 0x02000000

# Perform a Iota poweroff when we are done
exit-mode iota-off