view target-utils/flash-boot-test/uartinit.S @ 213:d5d6992897cf

loadtools/README renamed to README.old, previous README.old to README.older
author Mychaela Falconia <falcon@freecalypso.org>
date Fri, 19 May 2017 06:11:27 +0000
parents cc6594a7fc7a
children
line wrap: on
line source

/*
 * The UART initialization code in this assembly module has been lifted
 * from the disassembly of the Calypso boot ROM, and slightly adapted
 * for our needs.
 */

	.text
	.code	32
	.globl	uart_init

uart_init:
	stmfd	sp!, {r4-r11,lr}
@ prepare UART init values
	mov	r11, #3
	mov	r5, #0
	mov	r10, #7		@ baud rate divisor for 115200 baud
	mov	r9, #0x80
	mov	r7, #0xbf
	mov	r4, #7
@ UART base address
	ldr	r6, =uart_base
	ldr	r12, [r6]
	add	r3, r12, #8
@ R3 points to register 8 (MDR1)
@ write 07 into it: reset mode
	strb	r4, [r3]
	add	r0, r12, #3
@ R0 points to register 3 (LCR)
@ write BF into it: map in the extended registers
	strb	r7, [r0]
	add	r1, r12, #2
@ R1 points to register 2: EFR under current mapping
@ set bit 4: enable enhanced functions
	ldrb	r8, [r1]
	orr	r8, r8, #0x10
	strb	r8, [r1]
@ write 80 into LCR: map in the baud rate divisor registers
	strb	r9, [r0]
@ reg 2 (pointed to by R1) is now IIR/FCR
@ write 07 into FCR: FIFOs enabled and cleared, no DMA
	strb	r4, [r1]
@ write BF into LCR again
	strb	r7, [r0]
@ load baud rate divisor
	strb	r10, [r12]
	strb	r5, [r12, #1]
@ write 03 into LCR: restore normal registers, 8N1
	strb	r11, [r0]
@ write 00 into MDR1: plain UART mode
	strb	r5, [r3]
	ldmfd	sp!, {r4-r11,pc}