FreeCalypso > hg > freecalypso-tools
view loadtools/scripts/fcfam.config @ 1014:961efadd530a default tip
fc-shell TCH DL handler: add support for CSD modes
TCH DL capture mechanism in FC Tourmaline firmware has been extended
to support CSD modes in addition to speech - add the necessary support
on the host tools side.
It needs to be noted that this mechanism in its present state does NOT
provide the debug utility value that was sought: as we learned only
after the code was implemented, TI's DSP has a misfeature in that the
buffer we are reading (a_dd_0[]) is zeroed out when the IDS block
is enabled, i.e., we are reading all zeros and not the real DL bits
we were after. But since the code has already been written, we are
keeping it - perhaps we can do some tests with IDS disabled.
| author | Mychaela Falconia <falcon@freecalypso.org> |
|---|---|
| date | Tue, 26 Nov 2024 06:27:43 +0000 |
| parents | 49ee210fc4fb |
| children |
line wrap: on
line source
# This loadtool target configuration is intended to be applicable to all # original hardware designs created within the FreeCalypso project, # starting with FCDEV3B. Specifically, it should fit all targets that # satisfy the following criteria: # # The DBB chip is Calypso C035 # The RF block is Rita (26 MHz VCXO) # Spansion S71PL129NC0 used for flash and XRAM, copied from Pirelli DP-L10 # The 2nd flash chip select is wired to nCS2 # The following parameters go into the <p command sent to the boot ROM pll-config 4/1 # 26 MHz in, PLL&DSP @ 104 MHz, ARM @ 52 MHz rhea-cntl 0x00 # good for all Calypso platforms # The remaining settings are carried out via loadagent commands init-script cs2-4ws-8mb.init # Flash global config and chip select base addresses flash dual-8M 0x03000000 0x01800000 # Perform a Iota poweroff when we are done exit-mode iota-off