--- /dev/null	Thu Jan 01 00:00:00 1970 +0000
+++ b/loadtools/scripts/gen8.config	Thu Jan 30 06:59:03 2020 +0000
@@ -0,0 +1,20 @@
+# This config is meant to be applicable to most "generic" or "vanilla"
+# Calypso devices with just the following properties expected:
+#
+# * Calypso chip is C035, meaning it's ok to run the PLL at 104 MHz
+#   and give 52 MHz to the ARM7;
+# * There is one flash bank on nCS0 and one XRAM bank on nCS1;
+# * 8 MiB flash chip may be present, thus ADD22 needs to be enabled.
+
+# The following parameters go into the <p command sent to the boot ROM
+pll-config 4/1		# 26 MHz in, PLL&DSP @ 104 MHz, ARM @ 52 MHz
+rhea-cntl 0x00		# good for all Calypso platforms
+
+# The remaining settings are carried out via loadagent commands
+init-script basic-4ws-8mb.init
+
+# Flash configuration
+flash single-8M 0x03000000
+
+# Perform a Iota poweroff when we are done
+exit-mode iota-off

--- a/loadtools/scripts/tango.config	Thu Jan 30 06:03:42 2020 +0000
+++ /dev/null	Thu Jan 01 00:00:00 1970 +0000
@@ -1,13 +0,0 @@
-# The following parameters go into the <p command sent to the boot ROM
-pll-config 4/1		# 26 MHz in, PLL&DSP @ 104 MHz, ARM @ 52 MHz
-rhea-cntl 0x00		# good for all Calypso platforms
-
-# The remaining settings are carried out via loadagent commands
-init-script basic-4ws-8mb.init
-
-# This module has a single-bank 8 MiB flash chip on nCS0,
-# using the usual 0x03000000 mapping like on other targets
-flash single-8M 0x03000000
-
-# Perform a Iota poweroff when we are done
-exit-mode iota-off