view libtest/wavwriter.h @ 183:452c1d5a6268

libgsmefr BFI w/o data: emit zero output after decoder reset In real-life usage, each EFR decoder session will most likely begin with lots of BFI frames before the first real frame arrives. However, because the spec-defined home state of the decoder is speech rather than CN, our regular logic for BFI w/o data would have to feed pseudorandom noise to the decoder (in the "fixed codebook excitation pulses" part), which is silly to do at the beginning of the decoder session right out of reset. Therefore, let's check reset_flag_old, and if we are still in the reset state, simply emit zero output.
author Mychaela Falconia <falcon@freecalypso.org>
date Tue, 03 Jan 2023 00:12:18 +0000
parents 634df6435e16
children
line wrap: on
line source

/* ------------------------------------------------------------------
 * Copyright (C) 2009 Martin Storsjo
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *      http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either
 * express or implied.
 * See the License for the specific language governing permissions
 * and limitations under the License.
 * -------------------------------------------------------------------
 */

#ifndef WAVWRITER_H
#define WAVWRITER_H

#ifdef __cplusplus
extern "C" {
#endif

void* wav_write_open(const char *filename, int sample_rate, int bits_per_sample, int channels);
void wav_write_close(void* obj);

void wav_write_data(void* obj, const unsigned char* data, int length);

#ifdef __cplusplus
}
#endif

#endif