--- /dev/null	Thu Jan 01 00:00:00 1970 +0000
+++ b/chipsetsw/layer1/p_include/l1p_cons.h	Mon Jun 01 03:24:05 2015 +0000
@@ -0,0 +1,263 @@
+/************* Revision Controle System Header *************
+ *                  GSM Layer 1 software
+ * L1P_CONS.H
+ *
+ *        Filename l1p_cons.h
+ *  Copyright 2003 (C) Texas Instruments  
+ *
+ ************* Revision Controle System Header *************/
+
+// TBF allocations...
+#define  DL_TBF           0
+#define  UL_TBF           1
+#define  BOTH_TBF         2
+#define  SINGLE_BLOCK_DL  3
+#define  SINGLE_BLOCK_UL  4
+#define  TWO_PHASE_ACCESS 5
+#define  NO_TBF           6
+
+// MAC modes...
+#define  DYN_ALLOC         0
+#define  EXT_DYN_ALLOC     1
+#define  FIX_ALLOC_NO_HALF 2
+#define  FIX_ALLOC_HALF    3
+
+// First task after the Idle frame...
+#define  RX_TASK           1
+#define  TX_TASK           2
+
+// Status for interference measurement frame
+#define ANY_IDLE_FRAME     0
+#define PTCCH_FRAME        1
+#define SEARCH_FRAME       2
+
+// No measurement status
+#define NO_MEAS      0x80
+
+// Multislot bit of BBCTRL ABB register to set the multislot mode
+#if (ANLG_FAM == 1)
+  #define B_MSLOT (0x40<<6)
+#endif
+#if ((ANLG_FAM == 2) || (ANLG_FAM == 3))
+  #define B_MSLOT (0x20<<6)
+#endif
+
+//----------------------------------------
+// LAYER 1 Asynchronous processes names...
+//----------------------------------------
+#define NBR_L1PA_PROCESSES       11
+
+#define PI_SCP                   0   // l1pa_idle_paging_process(msg)
+#define TRANSFER                 1   // l1pa_transfer_process(msg)
+#define P_ACC                    2   // l1pa_access_process(msg)
+#define P_POLL                   3   // l1pa_idle_packet_polling_process(msg)
+#define SCPB                     4   // l1pa_serving_cell_pbcch_read_process(msg)
+#define CR_MEAS                  5   // l1pa_cr_meas_process(msg)
+#define TCR_MEAS                 6   // l1pa_tcr_meas_process(msg)
+#define PI_INT_MEAS              7   // l1pa_idle_interference_meas_process(msg)
+#define PT_INT_MEAS              8   // l1pa_transfer_interference_meas_process(msg)
+#define NCPB                     9   // l1pa_neighbor_cell_pbcch_read_process(msg)
+#define PI_SMSCB                10   // l1pa_idle_smscb_process(msg)
+
+// Constants for PRACH
+#define ACC_BURST_8              0
+#define ACC_BURST_11             1
+
+#define DYN_PRACH_ALLOC        1
+#define FIX_PRACH_ALLOC        2
+
+// DSP CS types (CHED)
+//TABLE/ UL CS
+#define CS_NONE_TYPE    0  //NAME/ No block
+#define CS_AUTO_DETECT  1  //NAME/ N/A
+#define CS1_TYPE_DATA   2  //NAME/ CS1
+#define CS1_TYPE_POLL   3  //NAME/ Poll NB
+#define CS2_TYPE        4  //NAME/ CS2
+#define CS3_TYPE        5  //NAME/ CS3
+#define CS4_TYPE        6  //NAME/ CS4
+#define CS_PAB8_TYPE    7  //NAME/ PRACH 8bit
+#define CS_PAB11_TYPE   8  //NAME/ PRACH 11bit
+//END_TABLE/
+
+// USF decoding for PRACH
+#define USF_INVALID              0
+#define USF_GOOD                 1
+#define USF_BAD                  2
+#define USF_FREE                 7
+
+// DSP tasks
+#define DL_PDSP_TASK       2  // Downlink task (Normal burst or Prach).
+#define UL_PDSP_TASK       2  // Uplink task (Normal burst or Prach).
+#define PB_PDSP_TASK       3  // Power measurement Burst task.
+
+// DSP tasks used in d_task_md
+#define INTERF_DSP_TASK    100  // Interference measurements
+#define INTERF1_DSP_TASK   101  // 1 Interference measurement
+#define INTERF2_DSP_TASK   102  // 2 Interference measurement
+#define INTERF3_DSP_TASK   103  // 3 Interference measurement
+#define INTERF4_DSP_TASK   104  // 4 Interference measurement
+#define INTERF5_DSP_TASK   105  // 5 Interference measurement
+#define INTERF6_DSP_TASK   106  // 6 Interference measurement
+#define INTERF7_DSP_TASK   107  // 7 Interference measurement
+#define INTERF8_DSP_TASK   108  // 8 Interference measurement
+#define PTCCHD_DSP_TASK    109  // PTCCH DL
+#define PTCCHU_DSP_TASK    110  // PTCCH UL
+#define PTCCHDU_DSP_TASK   111  // PTCCH DL and UL
+
+//---------------------------------------------
+// PTCCH activities
+//---------------------------------------------
+#define PTCCH_DL_BIT          0  // PTCCH DL bit position
+#define PTCCH_UL_BIT          1  // PTCCH UL bit position
+
+#define PTCCH_DL              (TRUE_L << PTCCH_DL_BIT)
+#define PTCCH_UL              (TRUE_L << PTCCH_UL_BIT)
+
+//---------------------------------------------
+// SINGLE activities
+//---------------------------------------------
+#define ALL_SINGLE          0xFF
+#define SINGLE_DL_BIT          0  // SINGLE DL bit position
+#define SINGLE_UL_BIT          1  // SINGLE UL bit position
+
+#define SINGLE_DL              (TRUE_L << SINGLE_DL_BIT)
+#define SINGLE_UL              (TRUE_L << SINGLE_UL_BIT)
+
+#define SINGLE_DL_MASK         ALL_TASK ^ SINGLE_DL
+#define SINGLE_UL_MASK         ALL_TASK ^ SINGLE_UL
+
+//---------------------------------------------
+// Status for MPHP_SINGLE_BLOCK_CON
+//---------------------------------------------
+#define SINGLE_UL_DONE     0
+#define SINGLE_STI_PASSED  1
+#define SINGLE_NO_TA       2
+#define SINGLE_DL_DONE     3
+
+
+//---------------------------------------------
+// MCU-DSP bit-field bit position definitions
+//---------------------------------------------
+// d_task_u_gprs...
+#define B_ACCESS_PRACH   13
+#define B_PTCCH_UL       14
+
+// d_task_d_gprs...
+#define B_PTCCH_DL       14
+
+// d_sched_mode_gprs...
+#define B_SWITCH         0   // Bit 0: switch to GPRS, Bit 1: switch to GSM.
+#define B_MAC_MODE       2
+#define B_RIF_RX_MODE    5
+
+// a_ctrl_abb_gprs or d_ptcchu_ctrl_abb_gprs...
+#define B_RAMP_GPRS      0
+#define B_APCDEL2_GPRS   2
+#define B_APCDEL1_GPRS   3
+#define B_AFC_GPRS       4
+#define B_RAMP_NB_GPRS   5
+#define B_MS_RULE        8  // set an additionnal interrupt for the DSP
+
+//---------------------------------------------
+// LAYER 1 PACKET PERIODIC MEASUREMENT TASKS...
+//---------------------------------------------
+#define P_CRMS      0                             // Packet Periodic Measurements task in Idle mode.
+#define P_TCRMS     1                             // Neighbour Measurement in Packet Transfer mode.
+
+#define P_CRMS_MEAS  (TRUE_L << P_CRMS)           // Set Packet Periodic Measurements task
+#define P_TCRMS_MEAS (TRUE_L << P_TCRMS)          // Set Neighbour Measurement Packet Transfer task
+
+#define P_CRMS_MEAS_MASK  ALL_TASK ^ P_CRMS_MEAS  // Mask Packet Periodic Measurement task
+#define P_TCRMS_MEAS_MASK ALL_TASK ^ P_TCRMS_MEAS // Mask Neighbour Measurement Packet Transfer task
+
+//--------------------------------------------
+// Paging macro definition
+//--------------------------------------------
+//-- Paging States used for PPCH reading blocks
+#define PPCH_POS_NOT_COMP 0
+#define PPCH_POS_COMP     1
+
+//-- Maximum Number of Packet Paging Blocks
+#define MAX_NBR_PG_BLKS   11
+
+//-- Paging Block index max
+#define MAX_PG_BLKS_INDEX 10
+
+//--------------------------------------------
+// PBCCH macro definition
+//--------------------------------------------
+//-- Maximum Number of PBCCH Blocks
+#define MAX_NBR_PB_BLKS   4
+
+//-- PBCCH index max
+#define MAX_PB_BLKS_INDEX 3
+
+/*--------------------------------------------------------*/
+/* Position of different blocs in a MF52.                 */
+/*--------------------------------------------------------*/
+#define PCCCH_0            0
+#define PCCCH_1            4
+#define PCCCH_2            8
+#define PCCCH_3           13
+#define PCCCH_4           17
+#define PCCCH_5           21
+#define PCCCH_6           26
+#define PCCCH_7           30
+#define PCCCH_8           34
+#define PCCCH_9           39
+#define PCCCH_10          43
+#define PCCCH_11          47
+
+//-- PBCCH block position
+#define B0_POSITION        0L
+#define B11_POSITION      47L
+
+// Power measurement constants
+// mode for power measurements
+#define PACKET_IDLE         1
+#define PACKET_TRANSFER     2
+// number of meas
+#define NB_MEAS_PACKET_IDLE 4  // Normal case 1RX + 3PW, if no RX=> 4PW
+
+// TX burst types
+#define TX_NB_BURST    0
+#define TX_RA_BURST    1
+
+// No power control packet transfer AGC algorithm phases
+#define SEARCH         0
+#define TRACK          1
+
+/*--------------------------------------------------------*/
+/* API addresses.........................                 */
+/*--------------------------------------------------------*/
+#define DSP_API_ADDRESS_BASE          0x00000800L   //
+#define ARM_API_ADDRESS_BASE          0xFFD00000L   //
+
+// Herebelow we define the MCU/DSP interface addresses as seen
+// by the DSP (DSP address space) considering address 0 basis.
+
+#if (DSP == 33) || (DSP == 34) || (DSP == 35) || (DSP == 36)
+  #define DSP_MAP_DB_W_PAGE_0_GPRS      0x00000050L   //
+  #define DSP_MAP_DB_W_PAGE_1_GPRS      0x00000064L   //
+  #define DSP_MAP_DB_R_PAGE_0_GPRS      0x00000078L   //
+  #define DSP_MAP_DB_R_PAGE_1_GPRS      0x0000009CL   //
+  #define DSP_MAP_NDB_ADR_GPRS          0x000001AEL   //
+  #define DSP_MAP_PARAM_ADR_GPRS        0x00000480L   //
+#else
+  #define DSP_MAP_DB_W_PAGE_0_GPRS      0x000004ADL   //
+  #define DSP_MAP_DB_W_PAGE_1_GPRS      0x000004C1L   //
+  #define DSP_MAP_DB_R_PAGE_0_GPRS      0x000004D5L   //
+  #define DSP_MAP_DB_R_PAGE_1_GPRS      0x000004F9L   //
+  #define DSP_MAP_NDB_ADR_GPRS          0x00000056L   //
+  #define DSP_MAP_PARAM_ADR_GPRS        0x000001F1L   //
+#endif
+
+// Herebelow we define the MCU/DSP interface addresses as seen
+// by the MCU (ARM address space) considering .
+
+#define DB_W_PAGE_0_GPRS   (ARM_API_ADDRESS_BASE + (DSP_MAP_DB_W_PAGE_0_GPRS * 2))   //
+#define DB_W_PAGE_1_GPRS   (ARM_API_ADDRESS_BASE + (DSP_MAP_DB_W_PAGE_1_GPRS * 2))   //
+#define DB_R_PAGE_0_GPRS   (ARM_API_ADDRESS_BASE + (DSP_MAP_DB_R_PAGE_0_GPRS * 2))   //
+#define DB_R_PAGE_1_GPRS   (ARM_API_ADDRESS_BASE + (DSP_MAP_DB_R_PAGE_1_GPRS * 2))   //
+#define NDB_ADR_GPRS       (ARM_API_ADDRESS_BASE + (DSP_MAP_NDB_ADR_GPRS * 2))       //
+#define PARAM_ADR_GPRS     (ARM_API_ADDRESS_BASE + (DSP_MAP_PARAM_ADR_GPRS * 2))     //