sciphone g2 connector

[Harald Welte]

Hi Alexander,

On Thu, Dec 16, 2010 at 11:06:49PM +0100, Alexander Huemer wrote:

> i tried to ascii draw the connector from the back (soldering) side. the
> rounded half of the connector on the upper side.  The pins i found described
> elsewhere on the internet are already marked.

As you can read from the Schematics page 8 (I/O connector), Pin 9 is the 
Charger/USB Power.

As you have already marked, 6+8 are UART and 10+12 is ground.

So you have to connect the ground of your power supply to 10 and/or 12, and the
+5V to pin number 9.

I've added the pin numbers to your  ASCII-ART:

>    --------------------------
>   (                          )
>  (                          ) |
> ( 1 2 3 4 5 6 7 8 9 0 1012 )
> +-------------------------+   |
> | |   |   |   |   |   |   |  /
> |   |   |   |   |   |   | | /
> +-------------------------+/
>             ^   ^     ^ ^ 
>             |   |     | |
>             |   |     | +--- GND
>             |   |     +----- GND
>             |   +----------- RX  (PC -> Phone)
>             +--------------- TX  (Phone -> PC)
 

-- 
- Harald Welte <laforge at gnumonks.org>           http://laforge.gnumonks.org/
============================================================================
"Privacy in residential applications is a desirable marketing option."
                                                  (ETSI EN 300 175-7 Ch. A6)