!GPRS config: fix long-standing AT+COPS chance hanging bug There has been a long-standing bug in FreeCalypso going back years: sometimes in the AT command bring-up sequence of an ACI-only MS, the AT+COPS command would produce only a power scan followed by cessation of protocol stack activity (only L1 ADC traces), instead of the expected network search sequence. This behaviour was seen in different FC firmware versions going back to Citrine, and seemed to follow some law of chance, not reliably repeatable. This bug has been tracked down and found to be specific to !GPRS configuration, stemming from our TCS2/TCS3 hybrid and reconstruction of !GPRS support that was bitrotten in TCS3.2/LoCosto version. ACI module psa_mms.c, needed only for !GPRS, was missing in the TCS3 version and had to be pulled from TCS2 - but as it turns out, there is a new field in the MMR_REG_REQ primitive that needs to be set correctly, and that psa_mms.c module is the place where this initialization needed to be added.

/************* Revision Controle System Header *************
 *                  GSM Layer 1 software 
 * L1AUDIO_VAREX.H
 *
 *        Filename l1audio_varex.h
 *  Copyright 2003 (C) Texas Instruments  
 *
 ************* Revision Controle System Header *************/

#if (AUDIO_TASK == 1)
  #if (SPEECH_RECO)
    #ifdef L1_SRBACK_COM 
      T_L1_SRBACK_COM l1_srback_com;
    #else
      extern T_L1_SRBACK_COM l1_srback_com;
    #endif  
  #endif
  #if (MELODY_E2)
    #ifdef L1_AUDIOBACK_MELODYE2
      T_AUDIO_BACK_MELODY_E2 audioback_melody_e2;
    #else
      extern T_AUDIO_BACK_MELODY_E2 audioback_melody_e2;
    #endif  
  #endif
#endif // AUDIO_TASK == 1