FreeCalypso > hg > freecalypso-tools
comparison loadtools/scripts/gen4.config @ 561:392525355ee7
loadtools/scripts: gtm900.config renamed to gen4.config
It turns out that a GTM900 variant exists with 8 MiB flash, thus -h gen8
needs to be used for GTM900 modules as the general case, and the old
-h gtm900 config is best renamed to -h gen4, although not currently official
for any actual target.
| author | Mychaela Falconia <falcon@freecalypso.org> |
|---|---|
| date | Thu, 30 Jan 2020 07:10:20 +0000 |
| parents | loadtools/scripts/gtm900.config@26bb2c069427 |
| children |
comparison
equal
deleted
inserted
replaced
| 560:641d816b1e91 | 561:392525355ee7 |
|---|---|
| 1 # This config is meant to be applicable to most "generic" or "vanilla" | |
| 2 # Calypso devices with just the following properties expected: | |
| 3 # | |
| 4 # * Calypso chip is C035, meaning it's ok to run the PLL at 104 MHz | |
| 5 # and give 52 MHz to the ARM7; | |
| 6 # * There is one flash bank on nCS0 and one XRAM bank on nCS1; | |
| 7 # * No more than 4 MiB flash, thus no ADD22. | |
| 8 | |
| 9 # The following parameters go into the <p command sent to the boot ROM | |
| 10 pll-config 4/1 # 26 MHz in, PLL&DSP @ 104 MHz, ARM @ 52 MHz | |
| 11 rhea-cntl 0x00 # good for all Calypso platforms | |
| 12 | |
| 13 # The remaining settings are carried out via loadagent commands | |
| 14 init-script basic-4ws-4mb.init | |
| 15 | |
| 16 # Flash configuration | |
| 17 flash single-4M 0x03000000 | |
| 18 | |
| 19 # Perform a Iota poweroff when we are done | |
| 20 exit-mode iota-off |